Sky baggrund
Sky baggrund

MAG welding process 135 - 49653

Goal:

After completing the course, you will have gained theoretical knowledge about conditions that are important for the practical application of MAG welding process 135 of edge and butt seams in plate, in the following areas:

  • Additives

  • Welding defects and control methods

  • Joint shapes and formation

  • Environment and safety

After completing the course, you can, based on instruction and guidance at a basic level, perform MAG welding process 135 of edge and butt seams in plate in material group 1.1 + 1.2 + 1.4, cf. CR/ISO 15608 in, material thickness 3-6 mm.

You can perform the following welds:

  • FW-P-PA - horizontal edge seam

  • FW-P-PG - edge seam vertically falling

  • FW-P-PB - standing edge seam

  • BW-P-PA - butt seam top down

  • BW-P-PG - butt seam vertically falling

All exercises are completed based on both oral and written instructions and are assessed visually in accordance with DS/EN ISO 5817, level C.

The welding courses are held in an open workshop.

Open workshops are flexible AMU courses offered to both employed and unemployed people. Open workshops mean that

There is the possibility of a flexible start. The courses run simultaneously at different levels, and the participants are taught individually. The training is completed when the individual participant meets the training goals.

An AMU certificate is issued.

teachers on the course

Ole Sloth Nielsen
Billede af medarbejder
Hanne Bjerring Idskov Nørgaard
Billede af medarbejder
Brian Sogaard Hansen
Billede af medarbejder
Thomas Korsholt Mogensbaek Andersen
Billede af medarbejder

contact persons

Palle T. Balzer
Sales and business developer paba@techcollege.dk +45 2526 6238
Billede af medarbejder
Berit Godsk
Education Secretary bj@techcollege.dk +45 7250 5244
Billede af medarbejder